Hack sim card viettel

Go to the web settings and then proxy address settings to change the primary and secondary addresses. Once you have entered a new proxy setting, press OK and then clear. Then reset the home page on your phone to Google or Yahoo or something similar. Hit OK and then your phone should reboot. After your phone comes back up use a laptop or a desktop computer to configure a dynamic IP address that your phone will use.

There are several freeware programs on the internet that will do the job for you, so do a Google search on dynamic IP addresses and take your pick of the programs available. Make sure you do this on your own phone as some cell phones will work using this method and some will not. One phone that is known to work in this manner is a phone manufactured by the LG Corporation.

You could cause the phone to stop functioning if you make a mistake doing this process, so take your time and make sure you know what you are doing. Some testing led to choosing a connector that matched up well with the thickness of a 1.

About 28, of them were used, and for a while in it was very hard to get a hold of that particular part, because they had cleaned everyone out!

The SIM card in your cellphone has only a limited number of physical connections — and by the time NFC technology came on the scene all but one of them was in use.

So the SWP works bi-directionally on just one wire ; one device modulates the voltage on the line, while the other modulates the current, essentially by switching a load in and out. This signalling protocol makes snooping on this data line tricky.

So to start off his explorations with SWP, [Nils] built his own transceiver. Of course, the Electron is just a GSM module tied to a microcontroller, and you can do the same thing with a Pi , some components, and a bit of wire.

The build is fairly basic — just an Adafruit Fona , a mah LiPo battery, a charge controller, and a fancy Hackaday Perma-Proto Hat , although a piece of perf board would work just as well in the case of the perma-proto board.

Connections were as simple as power, ground, TX and RX. With a few libraries , you can access a Pi over the Internet anywhere that has cell service, or send data from the Pi without a WiFi connection. If you decide to replicate this project, be aware you have an option of soldering the Fona module right side up or upside down.

Tough choices, indeed. By using our website and services, you expressly agree to the placement of our performance, functionality and advertising cookies.

Learn more. Banner image: An old version and a new version of the transceiver prototype. Thanks to [Tim Riemann] for the tip! Search Search for:. For PUK code, you can call the operator from another phone and identify yourself first, after you are done identifying yourself, you should then tell them about the issue you are facing and your mobile number for which you need the PUK code. Above we have mentioned the three basic ways to get your PUK code and all these are applicable on all your mobile phone devices.

Top This Week on UnlockBoot. Bypass iOS 7. We do not sell or host jailbreak services or tools.